The ICT-100A is a box with vertical arms supporting a toggle clamp. To perform in-circuit testing on a customized Printed Circuit Board (PCB), the ICT-100A hosts a custom-built Pogo Pin Cassette (PPC).
This is our most popular chassis and supports boards up to A5 (148mm x 210mm) in size.
Ingun ATS MA11 removable pogo pin cassette with 150mm x 240mm testable area. This kit requires additional hardware and assembly to be usable with a device under test. Fits inside the MA 2111 chassis.
Ingun ATS MA12 removable pogo pin cassette with 285mm x 240mm testable area. This kit requires additional hardware and assembly to be usable with a device under test. Fits inside the MA 2112 chassis.
If possible, place test points on the bottom of the PCBA with a diameter of 1mm and separation of centers of at least 2mm. If they need to be smaller or closer together, this can be accommodated with this additional service. This also allows for interfacing with the pins of thru-hole components using special pogo pin heads.
Assembly of light pipes between an IR emitter and IR detector with an actuated flag that interrupts the beam. This test is used to validate a motion sensing system.
Includes LED sensing hardware, design, and integration into a pogo pin cassette. Assumes all LEDs are on the same side of the PCBA. Analyzer outputs a voltage that indicates the color and brightness of the LED. Price shown is per LED.
Microphone testing performed with a USB speaker connected to a single board computer (SBC) in the Pogo Pin Cassette. This requires the addition of an SBC as well. Sound isolation of the device under test is not included.
Sometimes it is useful to include one of the other PCBAs from a design inside the test fixture to verify interoperability. The price shown is the amount per inter-board connector. This does not include the cost of the sample board.